How to Set the Temperature on a HAKKO FXD. 1. Turn ON the power. The display will show the following: 2. Let the temperature come up to the factory. View and Download Hakko Electronics FXD instruction manual online. FX- D Soldering Gun pdf manual download. When you use the HAKKO FX for the first time, note that calibration is required (Refer to the HAKKO FXD instruction manual.).
|Published (Last):||18 October 2005|
|PDF File Size:||12.40 Mb|
|ePub File Size:||18.32 Mb|
|Price:||Free* [*Free Regsitration Required]|
Please check to make sure that all items listed. Press the button to change the display to 2. The plastic parts are not insulators, they are conductors. Since the soldering iron can reach a very high temperature, please work carefully.
Be sure to ground the unit during use.
Apply the following service procedure as dictated by the conditions of usage. High-output temperature controlled soldering station 23 pages.
When making repairs or replacing. Don’t show me this message again. Don’t have an account? Please note that some languages may not be available depending on the product. Be sure to observe. Except the case especially indicated, always turn the power switch OFF and disconnect the power plug before performing any maintenance procedure. Then bend the iron cord at various locations along its length, including in the strain relief area.
If you press the button, the display will move to the password setting mode selection screen.
Efficient soldering depends upon the temperature, quality and quantity of the solder and flux. This product includes such features as electrically conductive plastic parts and grounding of the unit.
ENTER will be switched alternately if you press the button. Add to my manuals Add. High-output, temperature controlled soldering station 23 pages. Keep this manual readily accessible for reference. By pressing ‘print’ button you will print only current page. Turn the power off when the FXD is not in use for an extended period.
Comments to this Manuals Your Name. Got it, continue to nakko. Turn the power on while pressing the button. Use Adjustment Mode to perform the temperature adjustment. Either will be displayed if you press the button when is displayed. The factory default is “0: Page 4 Heater control will begin after the new set temperature is displayed.
Hakko Electronics FX-888D Instruction Manual
There are three choices for the password setting. The display will return to if you press the button after selecting. Page of 16 Go.
After use Always clean the tip and coat it with fresh solder after use. To print the manual completely, please, download it.
HAKKO | Soldering iron | HAKKO FXD
Enter text from picture: Heater control will begin after the new set temperature is displayed. Part Name Specifications Item No. Custom” is selected in the password setting.